I welded a tree stand and put the tree up about 9 or 10 days ago,
cutting about 2cm from the bottom and a few of the lowest limbs as
well. A steel bowl was placed under the tree trunk and a small chunk
of wood was used as a standoff. The standoff was smaller than the
diameter of the trunk, thinking that I would prefer to stress the
heartwood rather than the vasculature. A single bolt was driven into
the trunk 1-2cm for support, and guy-wires (Romex) were attached ~120
degrees relative to the bolt. (My welding equipment isn't proper and I
slacked off toward the end because things were taking so long)
The first night I soaked the tree in water with about half the
recommended strength of rooting solution ("" fertilizer with IBA (an
auxin) in it).
The next day I added soil to the brim of the bowl, and filled to a
muddy consistency with more water+rooting solution. I checked the
water level 2-3 days later and topped it off, then left home for 4
days, and topped it up as soon as I got home.
Since we put the tree up its had a strand of white LED Christmas
lights on it, and I'll try to get some more tomorrow. Now I'm thinking
about the best way to do this... i.e. what wavelength or mix of
wavelengths is best for glucose production?
dealextreme has some LED string lights (100, 150, 192, 300, 600 LEDs
per string) with different colors, some list the wattage (which
reviews sometimes say are incorrect) or mcd output or wavelength or
Christmas white $8.27 100 LED -
465-475nm $0.11/LED -
3300K - http://www.dealextreme.com/p/48w-3300k-600x3528-smd-led-warm-white-light-strip-10-meter-12v-65714
I also found this paper that says 720Hz pulsed LEDs increased growth
in potato plantlets over continuous-nonfluctuating (C-NF) mode.
Any suggestions? Maybe get a blue and a red strand of the SMD lights
from dx and build a controller to pulse each at 720Hz??
Rochester Institute of Technology
College of Science, Biotechnology/Bioinformatics
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To post to this group, send email to email@example.com.
To unsubscribe from this group, send email to firstname.lastname@example.org.
For more options, visit this group at http://groups.google.com/group/diybio?hl=en.